56" x 60" Offset Drain Placement Shower Kit with 165 Sqft Roll, 60" Shower Curb, Corners, Sealant, 4'' Square Drain Kit with Flange, and Drain Grate Included

What's Included

1 x Two piece tray set measuring 32" x 60" with offset drain placement
1 x Four piece extension set measuring 12" x 36" each

Technical Specifications

Length: 60"
Width: 56"
Outer Height: 2"
Inner Height: 1/2"
Drain Hole Diameter: 5"
Drain Flange Diameter: 12.5"

Documents & Images

• How To Install PDF
• 56" x 60" Tray Detail
• Tray Extension Detail

How to Install

1. Pre-fit the shower tray by measuring then cutting the tray to fit the desired placement.
2. Place and seal the shower tray.
   1. Apply modified thin-set mortar to the substrate using a 1/4" x 3/8" square-notched trowel.
   2. Place the TruSlope shower tray onto the thin-set mortar.
   3. Use TruSeal Sealant Adhesive or thin-set mortar to bond the butt joints of the tray pieces together.
3. Embed the tray into the mortar by firmly walking on the TruSlope tray.
4. Install the Trugard Drain by generously applying modified thinset mortar and embedding TruLine linear drain into the thin-set mortar.
5. Pre-fit the TruCurb by measuring and cutting the curb to length using a standard handsaw.
6. Pre-cut the floor pieces of the Trugard Vapor-shield allowing for the membrane to go up the wall at least three (3) inches by cutting the membrane six (6) inches longer the floor width. Use a non-sharp pencil to mark the wall to floor intersections and corners. Cut the full corner (3” x 3”) square out of the membrane and discard.
7. Apply modified thin-set mortar to: 1. The floor wall ends, 2. The edge of the shower tray using a 1/4” x 3/8” square-notched trowel. 3. Back butter the curb bottom and ends and then pressing the curb firmly into place.