49" x 60" End Drain Placement Linear Drain Shower Kit
From $908.59 Regular Price $1,397.83
To $1,029.83 Regular Price $1,584.35
In stock
What's In this Kit:
1 x Linear Drain - Choose from 3 styles (Classic, "S" Style, and Tile-In / Tileable) with sizes up to 48"
1 x 165 Sqft Waterproofing Membrane Roll
1 x 49" x 60" Shower Tray with end drain placement
1 x 60" x 4 1/2" x 5" Shower Curb
1 x Seals and Corners Kit - 4 inside corners, 2 oustide corners, 1 pipe seal, and 1 shower valve seal
1 x 10.3oz Tube of TruSeal Adhesive Caulk Sealant
About the Shower Tray:
49" x 60" Linear Drain Standard Tray with End Drain Placement
What's Included
1 x Four piece tray set measuring 49" x 60" with end drain placement.
Technical Specifications
Length: 49"
Width: 60"
Outer Height: 2 1/4"
Inner Height: 1 1/8"
Documents & Images
How to Install
- Pre-fit the shower tray by measuring then cutting the tray to fit the desired placement.
- Place the linear drain onto its side marking the trench length then cutting out the “trench cut-out area” so that the drain trench sits down into the tray and the drain flanges sit on top of the tray.
-
Place and seal the shower tray.
- Apply modified thin-set mortar to the substrate using a 1/4" x 3/8" square-notched trowel.
- Place the TruSlope shower tray onto the thin-set mortar.
- Use TruSeal Sealant Adhesive or thin-set mortar to bond the butt joints of the tray pieces together.
- Embed the tray into the mortar by firmly walking on the TruSlope tray.
- Install the Trugard Drain by generously applying modified thinset mortar and embedding TruLine linear drain into the thin-set mortar.
- Pre-fit the TruCurb by measuring and cutting the curb to length using a standard handsaw.
- Pre-cut the floor pieces of the Trugard Vapor-shield allowing for the membrane to go up the wall at least three (3) inches by cutting the membrane six (6) inches longer the floor width. Use a non-sharp pencil to mark the wall to floor intersections and corners. Cut the full corner (3” x 3”) square out of the membrane and discard.
- Apply modified thin-set mortar to: 1. The floor wall ends, 2. The edge of the shower tray using a 1/4” x 3/8” square-notched trowel. 3. Back butter the curb bottom and ends and then pressing the curb firmly into place.
| Features | What's In this Kit: |
|---|
