49.5" x 41" OneSlope Tray End Drain Placement Linear Drain Shower Kit

What's Included

1 x Two piece tray set measuring 49.5" x 41" with end drain placement.

Technical Specifications

Length: 49.5"
Width: 41"
Outer Height: 7/8"
Inner Height: 1/4"

Documents & Images

• How To Install PDF
• TruSlope Tray Brochure
• Linear Drain Brochure

How to Install

1. Pre-fit the shower tray by measuring then cutting the tray to fit the desired placement.
2. Cut a rectangular hole into the floor substrate in the desired drain location to allow the linear drain trench to snugly fit down into the floor substrate, with the drain flanges being supported by the floor substrate.
3. Place and seal the shower tray.
   1. Apply modified thin-set mortar to the substrate using a 1/4" x 3/8" square-notched trowel.
   2. Place the TruSlope shower tray onto the thin-set mortar.
   3. Use TruSeal Sealant Adhesive or thin-set mortar to bond the butt joints of the tray pieces together.
4. Embed the tray into the mortar by firmly walking on the TruSlope tray.
5. Install the Trugard Drain by generously applying modified thinset mortar and embedding TruLine linear drain into the thin-set mortar.
6. Pre-cut the floor pieces of the Trugard Vapor-shield allowing for the membrane to go up the wall at least three (3) inches by cutting the membrane six (6) inches longer the floor width. Use a non-sharp pencil to mark the wall to floor intersections and corners. Cut the full corner (3” x 3”) square out of the membrane and discard.
7. Apply modified thin-set mortar to: 1. The floor wall ends, 2. The edge of the shower tray using a 1/4” x 3/8” square-notched trowel. 3. Back butter the curb bottom and ends and then pressing the curb firmly into place.